Basic Operation; Advanced Operation - KlipXtreme Umbra Manual De Instrucciones

5. Status indicator light:
• Blue LED indicates that the device is turned on.
• Alternating green and blue LED indicates that the headset has entered into the
pairing mode.
• LED glows steady blue when the wireless connection has been established and
when a call is answered.
• Blue LED blinks every 3 seconds while streaming audio in Bluetooth
during an incoming call.
• Red LED glows steady during charging. It changes to solid blue when the
battery is fully charged.
6. 3.5mm input jack: Use it for wired playback.
7. Charging socket: Insert the micro-USB plug here to recharge the battery.
8. Built-in microphone: For hands-free calling and conferencing.
IV. Basic operation
Charge your headset
• Plug the supplied charging cable into the USB port of your computer or to a 5V
USB adapter to charge the battery.
• Make sure that the headset is fully charged before using it for the first time.
• The headset battery has to be initially charged for around 3 hours. Thereafter, the
battery will take from 1 to 2 hours to recharge.
• While the headset is being charged, the LED glows red.
• When the battery has reached full capacity, the LED turns solid blue.
V. Advanced operation
Pairing the headset with your mobile phone
1. Press and hold the Power button on the left ear cup for about 3 seconds. The
"power on" voice prompt will be heard when the device is initially turned on.
2. Next, set your Bluetooth
3. Place both devices not more than one meter away from each other.
mode and
®
4. The LED will blink alternatively blue and green accompanied by the "Bluetooth
mode" voice prompt. This indicates that the headset has entered into the pairing
mode and it is ready to be detectable for the first time.
5. On your mobile phone, tap the newly discovered audio device (KHS-672) being
displayed in the Bluetooth
6. When asked if you want to pair with it, click Yes or OK to accept.
7. If you have a lower Bluetooth
0000 (4 zeros).
8. If pairing is successful, the "connected" voice prompt will be heard and the LED
will change to steady blue. If after 60 seconds the pairing process fails, please repeat
steps 1 through 7 described above.
9. The headset will go automatically into standby mode after several minutes of
inactivity.
10. Turn off the headset when not in use to save battery power. "Power off" will be
heard to confirm your selection.
mobile device to "discover" the wireless headset.
®
list.
®
version, you may be prompted to enter the passkey
®
®