Installation Steps - LUND 26410032 Instrucciones De Instalación

Installation Steps

Identify the (4) mounting locations for each running board bracket by looking under the driver side of the vehicle and finding the holes
in the rocker panel. Note which holes correspond with the holes in the running board brackets. Mark the holes in the rocker panel with a
grease pencil. NOTE: For extended cab / double cab trucks, there are only (3) mounting locations.
1
Remove plastic plugs to uncover threaded inserts.
2
Align running board brackets so that the slots in the
brackets align with the holes located in Steps 2 and
3. Thread a bolt with lock and flat washers in the top
bracket hole and into the top hole in the rocker panel.
Do not tighten at this time. Repeat for remaining (3)
bracket mounting locations.
4
Install bolt and washers
NOTE: Actual application may vary slightly from illustrations.
Remove plugs
Front
Front passenger side shown
Driver side front mounting locations.
3
Thread another bolt with washers through the lower
bracket hole, and into either the factory installed nut,
or the U-nut, as applicable. Repeat for remaining (3)
5
Page 2 of 3
Front
bracket mounting locations.
Install bolt and washers