Safety Instructions Relating Specifically To The Equipment - MeisterCraft MMS 800 E Manual Del Usuario

5454210-Multi-Elek-man_a 02.12.11 09:49 Seite 59
g Keep handles dry, clean and free
from oil and grease. Slippery
handles do not allow for safe handling
and control of the tool in unexpected
situations.
h If devices are provided for the
connection of dust extraction and
collection facilities, ensure these
are connected and properly used.
Use of these devices can reduce dust
related hazards.
4 Power tool use and care
a Do not force the power tool. Use
the correct power tool for your
application. The correct power tool
will do the job better and safer at the
rate for which it was designed.
b Do not use the power tool if the
switch does not turn it on and off.
Any power tool that cannot be
controlled with the switch is
dangerous and must be repaired.
c Disconnect the plug from the
power source before making any
adjustments, changing accessories,
or storing power tools. Such
preventive safety measures reduce
the risk of starting the power tool
accidentally.
d Store idle power tools out of the
reach of children and do not allow
persons unfamiliar with the power
tool or these instructions to
operate the power tool. Power tools
are dangerous in the hands of
untrained users.
e Maintain power tools. Check for
misalignment or binding of moving
parts, breakage of parts and any
other condition that may affect the
power tool's operation. If damaged,
have the power tool repaired before
use. Many accidents are caused by
poorly maintained power tools.
f Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to
bind and are easier to control.
g Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking into
account the working conditions and
the work to be performed. Use of
the power tool for operations different
from those intended could result in a
hazardous situation.
5 Service
a Have your power tool serviced by a
qualified repair person using only
identical replacement parts. This will
ensure that the safety of the power
tool is maintained.
b To avoid hazards, damaged power
leads must be replaced by the
manufacturer or his customer service
representative.
6 – Safety instructions
relating specifically to
the equipment
• Use only sharp, undamaged saw
blades. Torn, bent or blunt blades
should be replaced immediately.
• Match the tool insert, stroke rate and
pendulum action to the material in
question. Pay attention to an even feed.
• The unit may only be operated with
the footplate (3) mounted. When
working, the footplate should always
rest against the work piece.
59