Basic Setup - BGS technic 8639 Manual De Uso

DISPLAY
A Start laser
B Measurement basis
C Minimum value
D Area / Volume
E Maximum value
F Pythagorean theorem, indirect measurement
G Storage data
H Main display area
I Battery
J Measurement unit
KEY
1 Start measurement
2 Selection basis side
3 Addition measurement
4 Shutdown / Clear
5 Backlight ON/OFF / Unit selection
6 Selection area, volume, Pythagorean theorem
7 Subtraction measurement

BASIC SETUP

1. Press button "MEAS"(1) to start the instrument and laser. The instrument enters under test mode.
2. The instrument will shut down 2 minutes later automatically in case of no operation.
3. Press button "CLEAR"(4) to clear the measured data. Long press to shut down the instrument.
4. Press button "UNIT"(5) to set the background light on/off. Long press to enter unit switching.
5. Press button
instrument is the bottom side.
MEASUREMENT
Press button "MEAS"(1) to start laser; press the key again for single measurement.
•
• The measuring results will be displayed on the main measuring display area.
• Press button "MEAS"(1) for long time to enter the continuous measurement model, in which the
measured maximum and minimum value will be displayed on the screen.
Press button "MEAS"(1) for short time to exit the continuous measurement mode.
•
Note: During the area, volume and Pythagorean proposition measurement, the use of continuous
measurement will be beneficial for users to accurately positioning the largest and shortest side.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
(2) to enter the selection of measuring basis side. The default basis side of the
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed