Diagnostic Software Access Dsa; Start Screen For Fsa System Software; Fsa System Software Language Configuration; Fsa System Software Screen Layout - Bosch FSA 740 Manual De Instrucciones

!
Measurements on the CRI Piezo are only permitted
with special adapter cables (optional accessories).
!
The measuring probes included in the test prod set
(1 687 010 153) can only be used for measurements
below 30 volt.
General procedure for measurements on the vehicle:
1. Switch off the ignition.
2. Connect the FSA 740 Edition with battery (B–) or
motor mass via connecting cable B–.
3. Connect required measuring lines to the vehicle.
!
Do not hold the measuring lines with your hand dur-
ing measurement.
4. Switch on ignition.
5. Perform measurement.
6. Switch off the ignition after measuring.
7. Disconnect measuring lines on the vehicle.
8. Disconnect connecting cable B–.
"
Measurement complete.
5.3

Diagnostic Software Access DSA

With DSA, you can:
R
Start Bosch applications (automatically as well).
R
Make interface settings.
R
Select DSA and Bosch application language.
R
Install software.
R
Update customer and vehicle data.
R
Terminate Bosch applications.
You will find more information in the DSA online help.
Robert Bosch GmbH
| FSA 740 Edition | 23
5.4

Start screen for FSA system software

Fig. 4: Start screen after device is switched on
i
If several applications are open, the speed of the
FSA system software may be impaired.
5.5 FSA system software language con-
figuration
In the "Settings" menu, you can also select the lan-
guage with which you want to work in FSA 740 Edition.
This language will then be used for the other Bosch ap-
plications as well.
5.6

FSA system software screen layout

Fig. 5: Functional screen layout
1 Program toolbar is displayed in all program levels: e.g. program
name, test step
2 Information box with information and instructions for operator
3 Status bar with information on the vehicle and sensors
4 Window area for test results
5 Hardkeys and softkeys
en
1 689 989 089 | 2018-03-24