Uline HOOVER H-7197 Manual Del Usuario página 4

HARNESS ERGONOMICS AND
HEIGHT ADJUSTMENT
NOTE: Phillips screwdriver needed to adjust the
harness.
NOTE: The harness has been designed and
engineered to accommodate a wide range of users
and can be adjusted to fit according to height. The
upper harness should sit between the shoulder blades
for a comfortable fit. The backpack is shipped with
the upper harness positioned with the center hole
mounted to the middle height adjustment setting.
For taller users, move the
upper harness up to the
height adjustment setting
shown in figure.
(See Figure 6)
For shorter users, move to the
height adjustment setting
shown in figure.
(See Figure 7)
1. To adjust the upper
harness, use a Phillips
screwdriver to remove
the screw from the height
adjustment setting. (See
Figure 8)
PAGE 4 OF 27
SETUP CONTINUED
Figure 6
Figure 7
Figure 8
2. Move the upper harness
and fully tighten screw
into the correct height
adjustment setting.
(See Figure 9)
USING BACKPACK VACUUM
NOTE: Do not use vacuum without both filter bag
and HEPA filters in place.
AMBIENT TEMPERATURE RANGE: 32°F – 104°F
1. Check to ensure both filter bag and filters are assembled
in the unit. Insert hose end firmly into hose inlet, with elbow
turned toward vacuuming side.
(See Figure 10)
Figure 10
Filter
Bag
Filter
2. Switch housing assembly will need to be attached to the
belt using the vertical strap with orange trim. Place the strap
through the top and
bottom slot of the
switch, underneath the
belt and position in
place with the Velcro
underneath the elastic
band. (See Figure 11)
3. Loosen shoulder straps
then lift backpack,
sliding both arms
through shoulder
straps. (See Figure 11)
Figure 9
Figure 11
0519 IH-7197