Uline HOOVER H-7197 Manual Del Usuario página 6

2. Charger LED status
indicator will turn
green when battery
is fully charged. If the
charger flashes red,
an error has occurred.
Remove and replace
battery. (See Figure 18)
3. When charging, the
fully lit LEDs on the
battery will indicate
charge level.
(See Figure 19)
TO OPERATE VACUUM
1. Insert battery into
vacuum housing
by grasping the
integrated handle
and pushing in firmly
until battery locks into
place. (See Figure 21)
NOTE: The words
on the battery
are right side up
when installed
correctly.
2. Verify power level
of the battery with
LEDs on the power
switch housing.
(See Figure 22)
NOTE: The
LEDs are only
illuminated when
the vacuum is on.
PAGE 6 OF 27
SETUP CONTINUED
Figure 18
66%-100% Charged
33%-66% Charged
10%-33% Charged
0%-10% Charged
Figure 19
OPERATION
Figure 21
66%-100% Charged
33%-66% Charged
10%-33% Charged
0%-10% Charged
Figure 22
4. To remove battery,
press the release
button and slide
battery forward while
holding down on
charger base.
(See Figure 20)
WARNING! To reduce the risk of personal injury,
remove battery before cleaning of servicing.
3. Press orange switch to
power up the unit.
(See Figure 23)
• ON: Hush™ mode
quiet cleaning.
• BOOST: High traffic
area cleaning. Turn off
by returning switch to
center position.
4. To remove battery,
grasp the integrated
handle while pressing
the release button. Slide
out from housing by
pulling while holding
down release button.
(See Figure 24)
Figure 20
Figure 23
Figure 24
0519 IH-7197