Hexaguard™ Activated Carbon Filter; Hepa Media Final Filter; Inlet Filter - Uline HOOVER H-7197 Manual Del Usuario

FILTERS
WARNING! To reduce the risk of personal injury,
remove battery before cleaning or servicing.
Do not operate vacuum without both inlet filter
and final filters in place.

HEPA MEDIA FINAL FILTER

The final filters assist in the filtration process to return
cleaner air to the room. There are two HEPA filters, one
on each side of the backpack.
1. Remove filter door by
pulling rear tab forward
and rotating out.
(See Figure 32)
2. Pull filter out by the
frame. Hand rinse in
cold water under low
pressure. Rinse only
surface facing inside of
machine. Allow to dry
and reposition into filter
housing. (See Figure 33)
3. To replace filter door,
align the two forward
facing tabs and rotate
into place. Press rear
tab until door snaps into
place. (See Figure 34)
IMPORTANT! Allow filter to dry completely
before replacing. Dry filter on edge so air
circulates on both sides of filter. This may take
up to 24 hours.
REPLACEMENT FILTERS:
Inspect HEPA media final filter (H-7197-FILT) every month,
rinsing when necessary. Check for wear of media and
replace if pleats are damaged. Change filter regularly
to maintain maximum performance.
PAGE 8 OF 27
MAINTENANCE CONTINUED
Figure 32
Figure 33
Figure 34
HEXAGUARD™ ACTIVATED CARBON FILTER
1. The HexaGuard™ filters
are located on the
inside of the filter door.
Pull to remove.
2. Hand rinse with cold
water. Allow to dry
before replacing.
REPLACEMENT FILTERS:
Replace HexaGuard™ filters (H-7197-CIF) yearly for
optimum performance.

INLET FILTER

The inlet filter is located on the inside, bottom of bag
housing and protects the motor from damage.
1. If the filter becomes
dirty, pull off the grill
and lift out the filter.
Hand rinse in cold water
under low pressure. Let
filter dry for 24 hours.
Reposition dry filter and
snap grill into place.
REPLACEMENT FILTER:
Inspect inlet filter (H-7197-MIF) every two weeks to keep
vacuum running at peak performance.
IMPORTANT! Allow filter to dry completely
before replacing. Dry filter on edge so air
circulates on both sides of filter. This may take
up to 24 hours.
LUBRICATION:
The motor is equipped with bearings which contain
sufficient lubrication for its lifetime. The addition
of lubrication could cause damage. Do not add
lubrication to motor.
Figure 32
Figure 33
0519 IH-7197