Stand Assembly & Adjustment; Cleaning - Vornado 133 Manual Del Usuario

STAND ASSEMBLY & ADJUSTMENT
(MODEL 683)
No tools required.
STAND ASSEMBLY
1. Insert power cord (A) into
the top of Pole and pull
through the bottom.
2. Push the Circulator Head
into the Pole. Push until
the Lock Release Button (B)
snaps through the Hole (C).
3. Remove the Fastening
Nut (D) secured on the
underside of the base.
Rotate Fastening Nut
A
counter-clockwise to
remove.
4. Assemble Legs onto the
base of Pole by pushing
each Leg onto the grooves
(E). Replace Fastening Nut
(D) by rotating clockwise to
secure all the Legs in place.
8
English
HEIGHT ADJUSTMENT
(32 - 38 INCHES)
1. Support the Circulator Head
(A) with one hand. Use your
other hand to loosen the
B Adjustment Collar (B) by gently
rotating it counter-clockwise.
A
2. Slowly raise or lower the
Pole to the desired height
C
and secure into position by
rotating the Adjustment Collar
clockwise until tight.
E
Note: Before adjusting the
height or rotating the head,
check that the power cord is
not tangled and able to move
B
freely.
After adjusting height, ensure
that the Adjustment Collar is
fully tightened and engaged to
ensure Circulator Head does
D not rotate and bind power
cord.

CLEANING

GRILL REMOVAL (MODEL 133)
Screwdriver required.
WARNING: To reduce the risk of electrical shock and injury to persons, unplug the circulator before removing grill.
1. Remove the 4 screws located
on the back of the inlet grill, at
roughly 2, 5, 7 and 10 o'clock
positions, to release the Front
Grill. Screw
2. Dust or wash Front Grill with a
mild dishwashing soap. Do not
place grill in the dishwasher. The
excessive heat can distort the
plastic.
3. To reattach - position the Front
Grill so the Vornado logo in
the center of the Front Grill is
straight. Replace all the screws.
Screw
Use the brush attachment on your
household vacuum cleaner to
vacuum any accumulated dust off
the Front Grill and Air Inlets.
Screw
Note: The motor is
permanently lubricated
and requires no oiling.
Screw
9
English