Maintenance; Filter - Emerson RIDGID WD1246 Manual Del Operador

SP6661-1 ES.qxd 11/28/07
Operation (continued)
1. Locate blowing port of your Wet/Dry
Vac.
2. Insert Tug-A-Long end of hose into the
blowing port of the vac.
3. (Optional) Attach extension wand to
swivel end of hose, then place a car
nozzle on the wand.
4. Turn vac on and you are ready to use
your vac as a blower.

Maintenance

Filter

!
WARNING: To reduce the risk of
injury from accidental starting,
unplug power cord before changing
or cleaning filter.
NOTE: The filter is made of high quality
paper designed to stop very small
particles of dust. The filter can be used
for dry pick up or small amounts of liquid.
Handle the filter carefully when removing
to clean or installing it. Creases in the
filter pleats may occur from installation
but will not affect the performance of the
filter.
Filter Cleaning
Your filter should be cleaned often to
maintain peak vac performance.
Be sure to dry the filter before storing or
picking up dry debris.
IMPORTANT: After cleaning, check the
filter for tears or small holes. Do not use
a filter with holes or tears in it. Even a
small hole can cause a lot of dust to
come out of your vac. Replace it
immediately.
Filter Removal
To remove the filter for cleaning or
replacement, unscrew the filter nut from
the filter cage and lift off filter and filter
plate .
1:07 PM Page 10
All manuals and user guides at all-guides.com
Tug-A-Long
filter cage and float. The float
prevents water from entering the
impeller and damaging the motor.
The cage prevents fingers from
touching the moving impeller.
IMPORTANT: To avoid damage to the
blower wheel and motor, always reinstall
the filter before using the vac for dry
material pick-up.
Cleaning A Dry Filter
1. Some removal of dry debris can be
2. For best cleaning results due to
3. After filter removal from vac, remove
4. For thorough cleaning of dry filter with
10
Hose
Extension
Wand
(optional)
Car
Nozzle
(optional)
!
WARNING:
Do not remove the
accomplished without removing the
filter from the vac. Slap your hand on
top of the lid while the vac is turned
off.
accumulated dust, clean the filter in an
open area. Cleaning SHOULD be
done outdoors and not in the living
quarters.
the dry debris by gently tapping filter
against the inside wall of your dust
drum. The debris will loosen and fall.
fine dust (no debris), run water
through it as described under
"Cleaning A Wet Filter"
Blowing
Port
Swivel
End of
Hose