Wet/Dry Vac Assembly - Emerson RIDGID WD1246 Manual Del Operador

SP6661-1 ES.qxd 11/28/07

Wet/Dry Vac Assembly

1. Line up vacuum port in top assembly
with drain cap located on the front of
the drum.
2. Place lid on top of drum with the drum
latches snug against the drum
channel.
3. Be sure lid completely covers the top
of the drum so leakage does not
occur.
4. Push down on top of the drum latch
areas to cause the flexible locking
tabs to hook onto the drum lip of the
channel.
WD1246
Push
Down
Pull Out
Flexible
Locking
Tab
WD1635
Drum
Channel
1:07 PM Page 6
All manuals and user guides at all-guides.com
5. Make sure that the locking tabs are
6. For WD1635, rotate both drum latches
Your new Wet/Dry Vac is ready for use.
Top Assembly
Drum
Channel
Locking Tab
Top Assembly
Push
Down
Pull Out
Drum
Latch Tab
6
snapped in place to prevent the lid
from coming off. (See inset).
down until you hear them snap over lip
of the drum.
Out
Flexible
Drum Latch
Out
Drum
Drum