Tabla de contenido
Publicidad
AGRETO VibroCounter II
7.3
Fastening the counter
Place the counter on the base plate.
Use the 4 allen screws M5x8. Two of them
have a small hole for the seal wire, use these
two on the side where you want to attach the
seal.
First, pull slightly down all 4 screws, and
then tighten every screw again so that the
housing is evenly pressed against the
mounting plate.
7.4
Attaching the seal
Thread the seal wire through the holes in the
two screws.
Thread both ends of the wire through a hole
in the seal.
Slide the seal as close as possible to the
meter and at the same time tighten the wire.
Close the seal.
If the hole of one of the screws is not accessible,
you can also drill a small hole in the housing bar
between the two screws and pull through the seal
wire here.
© AGRETO electronics GmbH
page:9
Publicidad
Capítulos
Tabla de contenido
