Wet Vacuum Cleaning - SPARKY VC 1220M Manual De Instrucciones

▪ Set the vacuum cleaner switch (2) to the "ON"
position "I".
▪ Set the automatic mode switch (3) into position
"=".
▪ Switch on the power tool.
The vacuum cleaner will switch on automatically
as soon as you switch on the power tool. When

WET VACUUM CLEANING

WARNING: Never vacuum up hazard-
ous materials.
▪ Make sure that the appliance is not plugged into
the power mains.
▪ Check to make sure that the tank (10) is free of
dust and dirt.
▪ The appliance is shipped from the factory with
a pleated filter. Remove the pleated filter (18)
which is not appropriate for wet vacuum clean-
ing.
▪ Remove the dust bag (24) and the dry filter (20)
in case you have used them prior to wet vacu-
um cleaning (VC 1220M).
▪ Only leave the foam plastic filter (19) (Fig.12)
over the filter basket.
▪ Place the upper section on the tank once again
and close the clamps (Fig.7), (Fig.8).
▪ Place the large end of the hose on the front air
intake stub on the tank (Fig.9).
▪ Select a nozzle (15, 17, 25) or the telescopic
tube (14) and slide it over the suction tube (13),
(Fig.10).
▪ Make sure that the ON/OFF switch (2) on the
appliance is in the "OFF" position "O" before
you plug the power plug into the socket.
▪ Insert the plug into the socket.
Original instructions
you switch off the power tool, the vacuum cleaner
will also switch off after a pre-set delay.
EU
RU
B
▪ Switch the motor on (ON/OFF switch (2) in posi-
tion "I").
▪ When you have finished wet vacuuming, switch
the motor off by putting the ON/OFF switch (2)
into the „OFF" position "O".
▪ Unplug the vacuum cleaner.
▪ After use, empty and dry the tank (10).
Tip: If you want to vacuum up a large quantity of
liquid from a sink or a tank, please don't put the
entire suction nozzle in the liquid; rather leave a
little space so that some air can also be drawn in
along with the liquid.
The appliance is equipped with a float switch (5)
(Fig. 18) that will stop the vacuuming when the
tank is full. You will notice that suction has stopped
by the motor now running faster. In this event,
switch the appliance off and unplug it.
Be aware that the full tank can be very heavy.
Remove the cap from the drain outlet (21) and
pour the rest of the liquid into a suitable tank or
drain. Then, you can continue vacuuming after
you have replaced the drain outlet cap.
After wet vacuuming, switch off the appliance and
unplug it. Empty the container and clean/dry it in-
side and outside before putting it away.
IMPORTANT! After wet vacuuming, please pro-
ceed as described in the section entitled „Dry
Vacuum cleaning" before you dry vacuum again.
A (Voltage) B (Power input)
230 V 2100 W
220V 2000 W
A
7
EN