How To Stop Your Pressure Washer; How To Use Accessory Tray - Generac 1538-1 Manual Del Propietário

Ocultar thumbs Ver también para 1538-1:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Figure 15 — Throttle Positions
Throttle Lever
Fast
• Move the choke lever to the "Closed" position
(Figure 16).
Figure 16 — Choke Positions
Choke Lever
Closed
NOTE: For a warm engine, be sure the choke lever is in
the "Open" position.
• Set the engine switch to the "On" position (Figure 17).
Figure 17 — Engine Switch
• Grasp starter grip and pull slowly until you feel some
resistance. Then pull cord out with rapid full arm stroke.
Let rope return slowly. Do Not let rope "snap back"
against starter.
• If the choke lever has been moved to the "Closed"
position to start the engine, gradually move it to the
"Open" position as the engine warms up.
Generac Portable Products 2,500 PSI High Pressure Washer
Slow
Open
Engine Switch
Off
On
NOTE: If the recoil starter is hard to pull, it may be
necessary to squeeze the gun trigger to relieve internal
pump pressure.

How to Stop Your Pressure Washer

• Move the throttle lever to the "Slow" position.
• Wait for the engine to idle down.
• Move the engine switch to the "Off" position.
• Simply shutting off the engine will not release pressure in
the system. Squeeze trigger on the spray gun to
relieve pressure in the hose.

How to Use Accessory Tray

The unit is equipped with an accessory tray with places to
store your nozzle extension and quick connect nozzles, and
slots to hold the cleaning solution bottle and the detergent
siphoning filter. There are also two hooks at the ends of
the handle to hold your spray gun and high pressure hose.
NOTE: The extra holes in the tray are for storing a brush
and a turbo wand. The brush and turbo wand are NOT
included with your pressure washer. You can buy these
items as optional accessories.
• Place the nozzle extension through the hole on the
accessory tray, as shown in Figure 18.
Figure 18 — Typical Accessory Tray
• Hang your chemical solution bottle on the "J" hook and
place the detergent siphoning filter in the last slot on the
left (Figure 18).
• Place the spray gun on the hook attached to the
accessory tray on the right side of the unit (Figure 18).
9

Publicidad

Tabla de contenido
loading

Tabla de contenido