How To Use - Pixel Voical Air Guia Del Usuario

How to Use

time; the channels of transmitter A, transmitter B must be the
same as the channel of receiver.
For example: for A channel, the signal channel of the
transmitter is set as CH01 and the signal channel of the
receiver is set as CH01; the schematic diagram is as follows:
2.How to set the AB group of the transmitter?
Press and hold the " " set button and "-" button at the same
time, release the buttons after the "A or B" flashes on the left
side of the screen, short press the power button to switch group
A or group B. After adjustment is completed, press the "
button again to exit, or, it will automatically exit and save the
channel adjustment after 3 seconds.
3.How to set the transmitter channel?
Press transmitter " " set button, When the "CH**" character
flashes, you can adjust the channel by pressing "+" and "-"
button. After adjustment is completed, press the "
again to exit, or, It will automatically exit and save the channel
adjustment after 3 seconds.
4.How to set the receiver group and channel?
Press receiver " " set button once, when the "A-CH**"
character flashes, you can adjust the channel by pressing "+"
and "-" button. After adjustment is completed, press the "
button again to exit, or, it will automatically exit and save the
channel adjustment after 3 seconds.
Press receiver " " set button twice, when the "B-CH**"
character flashes, you can adjust the channel by pressing "+"
and "-" button. After adjustment is completed, press the "
button again to exit, or, it will automatically exit and save the
channel adjustment after 3 seconds.
6
How to Use
5. You can directly adjust the transmitter DB sensitivity by
pressing the "+" and "-" buttons.
6. You can directly adjust the receiver monitor volume by
pressing the "+" and "-" buttons.
5. Charging
When the battery capacity is low, it shows red, during charging,
+
the lightning sign is shown and the charging grid runs slowly,
after the battery capacity is full, the charging grid stop running.
" set
After using Type-C interface 5V 1A input, the microphone can
+
work continuously.
" set button
" set
" set
7