Tripp-Lite B126-1A1-WHD3 Manual Del Propietário página 4

Installation
Notes:
1. Ensure all equipment being connected is powered off prior to installation.
2. For best results, position the IR transmitter near the HDMI source and IR receiver
near the display.
3. If the wireless signal is obstructed by walls (especially brick or glass) or other sources
of interference, the quality and distance of the signal will likely be reduced.
Blu-ray
HDMI Cable
1. Optional: Attach the included mounting hardware to the transmitter and
receiver units, then mount them to a desired location.
2. Connect the HDMI source device to the HDMI Input port on the transmitter
unit using an HDMI cable, such as Tripp Lite's P568-Series High-Speed
HDMI Cables.
3. Connect the IR-OUT (Tx) cable to the IR-OUT port on the transmitter unit.
Note: IR-OUT (Tx) cable has IR-OUT marked on the bottom of the IR bulb. Place the
bulb of the IR-OUT (Tx) cable in an area with a direct line of sight to the HDMI source
device (e.g. Blu-ray player).
4. Connect the external power supply to the transmitter unit, and plug it into
a Tripp Lite Surge Protector, Uninterruptible Power Supply (UPS) or Power
Distribution Unit (PDU).
5. Connect the HDMI display to the HDMI Output port on the receiver unit using
a P568-Series High-Speed HDMI Cable.
6. Connect the IR-IN (Rx) extension cable to the IR-IN port on the receiver unit.
Note: IR Receiver cable has IR-IN marked on the bottom of the IR bulb. Place the
bulb of the IR receiver cable in the general area you will be using the source device's
remote control.
7. Connect the external power supply to the receiver unit, and plug it into a
Tripp Lite Surge Protector, Uninterruptible Power Supply (UPS) or Power
Distribution Unit (PDU).
8. Turn on power to the connected equipment.
/DVD
™
HDMI Extender
Tx Transmitter
4
TV (Up to 1080p)
HDMI Cable
HDMI Extender
Rx Receiver