Tripp-Lite B127-1A1-HH Manual Del Propietário página 13

Splitter Daisy-Chain Installation
(B127-004-H only)
1. Make sure all equipment in the installation—such as TVs, Blu-ray
players and the transmitter—is powered OFF.
2. Using an HDMI 2.0 cable (such as Tripp Lite P569-XXX-CERT or
P568-XXX-2A Series cables), connect the HDMI source to the INPUT
port on the B127-004-H unit.
3. Using a 6 ft./1.83 m HDMI 2.0 cable (such as Tripp Lite
P569-006-CERT or P568-006-2A cables), connect the LOCAL port on
the B127-004-H to the INPUT port on a second B127-004-H unit.
4. Repeat step 3 if connecting a third B127-004-H unit.
Note: Only three levels of splitters can be cascaded.
5. Optional: Using an HDMI 2.0 cable (such as Tripp Lite
P569-XXX-CERT or P568-XXX-2A Series cables), connect a local
monitor to the LOCAL HDMI port of the last B127-004-H unit in the
installation.
6. Using Cat6 cable, connect one of the RJ45 output ports on the local
transmitter units to the RJ45 input port on a B127-100-H or
B127-100-H-SR remote receiver unit.
7. Repeat step 6 for each additional remote unit being connected.
8. Using an HDMI 2.0 cable (such as Tripp Lite P569-XXX-CERT or
P568-XXX-2A Series cables), connect the B127-100-H or
B127-100-H-SR to a display.
9. Repeat step 8 for each additional monitor you are connecting to a
remote receiver unit.
10. Turn on the power to all your connected displays.
11. Connect the external power supply to the local transmitter unit and
plug it into an available wall outlet or (optional) a Tripp Lite Surge
Protector, Power Distribution Unit (PDU) or Uninterruptible Power
Supply (UPS). The POWER (green) LED will illuminate to indicate the
unit is receiving power from the external power supply.
1-427-933919.indb 13
13
3/18/2019 4:56:30