Omnifilter K2 Manual Del Propietário página 3

A. Slip a brass ferrule (ring) into the large
end of one of the compression nuts.
See Figure 5.
B. Gently thread the nut with the ferrule onto
the union. Be sure the union bottoms out
against the ferrule. See inset drawing
of Figure 5.
C. Push the copper tubing into the small end
of the compression nut as far as it will go
(about 1/2-inch).
D. Tighten the unions with a wrench.
Small
end of
Compression
Nut
Nut &Ferrule
Copper
Water
Line
Figure 5
Tubing Assembly
Small end
Poly-tubing
Large
end
Complete Tubing Assembly
Figure 6
4148 0202
Large
end of
Compression
Nut
Brass
Ferrule
Union
NOTE:
The ferrule butts
up against the union.
Ferrule
Union
Brass
Compression
Nut
Large end
Plastic
Compression
Sleeve
Small
end
Nut and Sleeve
Brass
Insert
9. Cut the poly tubing into two pieces.
10. Attach a tubing assembly to each of the ends
of the poly tubing:
A. Take the end of one of the pieces of poly
tubing and slide a brass compression nut
over the end (small end first). See Figure 6.
B. Slide a white plastic compression sleeve
(large end first) over the end of the tubing
and into the nut.
C. Place a brass insert inside the end of
the tubing.
D. Connect the tubing assembly at the four
locations as shown in Figure 7.
NOTICE: The poly tubing will wear with
time. Replace tubing if necessary.
For further operating, installation, or
maintenance assistance:
Call Omnifilter Customer Service
4204 0602 www.omnifilter.com
3
Tubing
Assembly
Tubing
Assembly
Tubing
Assembly
4141 0202 final
at 800.937.6664;
Delavan, WI 53115
Tubing
Assembly