Basic Operation; Fm Radio Operation - Tokai TB-133PE Manual De Instrucciones

Switching ON for the first time
Plug into AC power or install batteries by following instructions on the previous Power Supply section.
The standby indicator will light (on the top of the unit) once the unit is connected to the main power.
Press the POWER button to turn the unit ON (the standby indicator will be OFF).
Switching between different sources (Radio / CD / USB / AUX)
After turning ON the unit, press the SOURCE button to select the different sound sources (each press
will select : FM Radio mode, CD mode, USB mode, AUX mode).
Adjusting sound volume level
Turn the VOLUME knob to adjust the level of sound volume.
Adjusting the telescopic antenna
The telescopic antenna should be fully extended to ensure good reception in FM radio mode. It may
be necessary to adjust the position of the unit and /or antenna to achieve the best signal reception.
The unit is designed to receive FM Radio band.
TUNING THE FM RADIO
1. Press the POWER button to turn the unit ON (the standby indicator will be off).
2. Press the SOURCE button repeatedly to switch the unit to the FM radio mode.
3. To launch the auto-searching, Rotate and hold the TUN+/-&NEXT/PREV CONTROL several
seconds and then release it.
4. Rotate the TUN+/-&NEXT/PREV CONTROL to and fro shortly to tune the radio stations manually.
5. Adjust the volume level to a comfortable listening level.
6. Press the POWER button to turn OFF the unit.
NOTE:

When FM (stereo) station is received, the FM ST. indicator will light on the top of the unit.

The FM TELESCOPIC ANTENNA is directional. When you are receiving an FM broadcast, fully
extend the TELESCOPIC ANTENNA and rotate it for the best reception.
STORING YOUR FAVORITE RADIO STATION
1. Tune to your favorite station first; press the MODE/PROG/MEM button for storing the current station
until memory cell number flashes on the screen.
2. Use the STOP/CH- button or the PLAY/PAUSE/CH+ button to select the corresponding memory cell
among P01-P20 for storing the station.
3. Confirm your selection by pressing the MODE/PROG/MEM button.
Note : You can store up to 20 radio stations in the unit memory.
4. During radio playback, press the STOP/CH- button or the PLAY/PAUSE/CH+ button repeatedly to
recall the preset stations.

BASIC OPERATION

FM RADIO OPERATION

17