Troubleshooting - Tokai TB-133PE Manual De Instrucciones

To Clean the Lens
If the lens get dirty, your player may skip or may not play a CD
1. Open the CD door.
2. Use a camera lens blower/brush to blow on the lens once or twice, brush the dust or particles off the
lens then blow again.
3. To remove fingerprints, use a dry cotton swab to wipe from the middle to outer edge of the lens.
If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to
remedy a problem by following these hints, consult you dealer or service center.
WARNING: Under no circumstances should you try to repair the set yourself, as this would invalidate
the guarantee.
PROBLEM
No sound in general
The unit does reset to
operation of any button
Radio poor reception
CD cannot read
No sound in USB mode
TROUBLE SHOOTING
POSSIBLE CAUSE
Volume not adjusted.
Mains supply is not correctly
connected.
Under the influence of
electrostatic phenomenon, the
product may malfunction and
require user to disconnect.
Weak radio aerial signal.
Interference caused by the vicinity
of electrical equipment like TVs,
video recorders, computer,
thermostats, fluorescent lamps
(TL) engines etc.
The disc is dirty.
The disc is upside down.
The CD player is in Pause mode
Volume at minimum.
External device not connected
properly.
REMEDY
Adjust the Volume knob.
Connect the mains supply
properly.
Turn off the unit, disconnect the
mains plug, and reconnect after a
few seconds.
Aim the aerial for best reception.
Fully extend the telescopic
antenna.
Keep the unit away from electrical
equipment.
Clean or replace the disc.
Turn it over so that the label is
face up.
Release the Pause Mode by
pressing the Play/Pause button.
Adjust the volume knob.
Clear contact pins and connect
again.
21