Tripp-Lite B127P-002-H El Manual Del Propietario página 8

Standard Extender/Splitter Installation
1. Make sure all equipment in the installation—such as TVs, Blu-ray
players and the transmitter—is powered OFF.
2. Using an HDMI 2.0 cable (such as Tripp Lite P569-XXX-CERT or
P568-XXX-2A Series cables), connect the HDMI source to the INPUT
port on the B127P-002-H or B127P-004-H.
3. Optional for B127P-004-H: Using an HDMI 2.0 cable (such as
Tripp Lite P569-XXX-CERT or P568-XXX-2A Series cables), connect an
HDMI monitor to the LOCAL port on the B127P-004-H unit.
4. Using Cat6 cable, connect the RJ45 port on the local transmitter unit
to the RJ45 port on the remote receiver unit.
5. Repeat Step 4 for each additional remote unit being connected.
6. Using an HDMI 2.0 cable (such as Tripp Lite P569-XXX-CERT or
P568-XXX-2A Series cables), connect the remote receiver unit's HDMI
port to a monitor.
7. Turn the power on to your connected TVs/monitors. The LOCAL
(orange) LED will illuminate to indicate the local port has been
connected to a display.
8. Connect the external power supply to the local transmitter unit, and
plug it into an available wall outlet or (optional) a Tripp Lite Surge
Protector, Power Distribution Unit (PDU) or Uninterruptible Power
Supply (UPS). The POWER (green) LED on the local transmitter unit
will illuminate to indicate the unit is receiving power from the external
power supply. The POWER (green) LED on the remote receiver unit
will illuminate to indicate the unit is receiving power from the local
transmitter unit through PoC technology.
9. Turn on the power to the HDMI source. The OUTPUT (orange) LED
on the local transmitter unit illuminates to indicate a signal is being
received from the source. Additionally, the OUTPUT (orange) LED will
illuminate for each port signal connection.
8