Connecting The Water Supply Hose / Sink Faucet Connection - Avanti CTW14X0W-IS Manual De Instrucciones

CONNECTING THE WATER SUPPLY HOSE
The water supply hose must be connected to the washing machine at one end and to the water faucet
at the other. Do not stretch the water supply hose. If the hose is too short and you do not wish to move
the water faucet, replace the hose with a longer, high-pressure hose.
Select appropriate faucet as shown in the figures below. If none of these faucets are available, use the
faucet adapter provided.
The end of faucet spout should be longer than 10mm (0.4"), or the connector cannot be fixed properly.
Water leakage could develop.
If you have both cold and hot water supplied, connect the inlet hoses by matching cold to cold and hot
1. Connect the water inlet hoses to the faucets
by turning the connecting nuts.
CONNECTING
NUT
WATER INLET HOSE
Be sure the rubber rings are inside the connecting nuts.
2. Unscrew the lid of hot water connector
in water mixing valve, and then connect
the other end of water inlet hoses to the
connectors in water mixing valve by
turning the connecting nuts.
CONNECTING
NUT
WATER
INLET HOSE
CONNECTING
NUT
10
to hot.
HOT WATER
CONNECTOR
COLD WATER
CONNECTOR