Before First Time Use; Step 11 - Completing The Installation - Angelcare AC1200 Manual Del Proprietário

6
7
CLIC!
4 3
8
4
3
2
1
10
WARNING
STRANGULATION HAZARD
• Remove all slack from Sensor Pad Cord.
• When lowering the mattress support
as your child grows, slide the vertical
Cord Cover (5) upward so it remains
approximately in the center between
the mattress support and the floor. Slide
the Sensor Pad Cord through the Floor
Cover to eliminate any additional slack.
All manuals and user guides at all-guides.com
3"
6
6) Place the 6
7) Snap together the remaining cord
8) Remove any cord slack to make sure
2 1
9) Peel off the double-sided tape on the
10) Install the Nursery Unit on a flat, stable
9
11) Check to make sure the Sensor Pad has
12) Place the mattress back inside the crib.
• The Sensor Pad is not designed for use
• Discontinue used of the Sensor Pad
• BEFORE FIRST TIME USE: To test
cord cover approximately
th
3 inches (8 cm) from the edge of the
mattress support.
covers that will run along the floor.
no parts of the cord are loose.
4 th cord cover and place it securely
under the crib leg.
surface facing the crib at a distance of
at least 36" (1 m) and plug the Sensor
Pad cord into the Nursery Unit.
not moved from position.
The Sensor Pad functions with any size
and type of mattress except memory-foam
mattresses and hollow frame mattresses.
The hardboard maintains a constant
pressure on the Sensor Pad, enabling it to
detect the baby's movements even when
the baby is at the edges of the crib.
with adults, children or infants older
than 24 months.
when child is older than 24 months.
Remove Sensor Pad from crib and store
for future use.
that the unit is ready for use, refer to
instruction manual on how to test that
the installation has been done
E
N
19