Angelcare AC1200 Manual Del Proprietário página 5

system should NOT be located in the
vicinity of overhead power lines or other
electric light or power circuit, or where it
can fall into such power lines or circuits as
contact with them may be fatal.
15.20 S T R A N G U L AT I O N
Children have STR ANG LED in cords .
Keep adapter cords out of the reach of
children (more than 3 feet [0.9 m] away).
NEVER use sensor pad
without the protective
cord covering. Check
p r o t e c t i v e
covering before each
u s e .
d i s c o n t i n u e
sensor pad if protective
covering is damaged or broken.
15.21 Never use extension cords with
AC adapters. ONLY use the AC adapters
provided.
15.22 This monitor uses public airwaves to
transmit signals. Your monitor may even be
picked up by other households. To protect
your privacy, make sure monitor is turned
OFF when not in use.
15.23 Vibration Source - When the monitor
is in use, DO NOT use a crib mobile or
other crib accessories that may produce
vibrations. Other sources of vibrations
may include fans, washing machines, loud
music, etc. These sources of vibration may
interfere with the performance of your
Angelcare ® monitor and the alarm will
not sound if it continues to detect any
movement other than your baby's. Be sure
all vibration sources are eliminated before
using the monitor.
You may experience false alarms for several
reasons. The most common reason is the
Camera has not been turned OFF after you
have removed your baby from the crib.
Another reason is the Sensor Pad has not
been placed under the mattress properly.
Be sure the Sensor Pad is on a flat, firm
surface with the printed side facing up.
The sensitivity level may also need to be
adjusted. Refer to Step 12. Always be sure
to immediately check on baby whenever
an alarm sounds.
15.24 Sensor Pad - If the crib has a
spring or slat base, place a hard board
between the crib base and the Sensor
Pad measuring at least 13" x 13" (33 x 33
cm) and 1/4 inch (6 mm) thick. Only use
your Angelcare ® monitor in a stationary
sleeping environment such as a crib where
All manuals and user guides at all-guides.com
the Sensor Pad can rest on a completely
flat, firm surface.
16. IMPORTANT SAFETY INSTRUCTIONS
RELATED TO USE OF BATTERIES
H A Z A R D -
16.1 Use ONLY the type and size of batteries
specified in the owner's manual. There is a
risk of explosion if batteries are replaced
with an incorrect type.
16.2 DO NOT use these adapters with any
other equipments.
c o r d
16.3 When unplugging the AC Adapter from
I m m e d i a t e l y
the Camera, be sure it is switched to the
u s e o f
OFF position. If it isn't, the unit will revert
to battery mode if batteries are installed.
16.4 DO NOT use rechargeable batteries in
the Camera. Use alkaline batteries ONLY.
16.5 DO NOT dispose batteries in fire. They
may explode. Check with local regulations
for possible special disposal instructions.
16.6 Exercise care in handling batteries
in order not to short out the batteries
with conducting materials such as rings,
bracelets and keys. Overcharging, short
circuiting, reverse charging, mutilation, or
incineration of batteries must be avoided
to prevent one or more of the following
occurrences: release of toxic materials,
release of hydrogen and/or oxygen gas
and rise in surface temperature.
16.7 DO NOT attempt to recharge batteries
provided with or identified for use with
this product that are not intended to be
charged. The batteries may leak corrosive
electrolyte or explode.
16.8 DO NOT attempt to rejuvenate the
batteries provided with or identified for use
with this product by heating them. Sudden
release of battery electrolyte may occur,
causing burns or irritation to eyes or skin.
16.9 If and when necessary, the batteries
must be replaced with identical new ones
or equivalent (volts and size). If a battery
to be replaced is connected with other
batteries in series, replace the other
batteries at the same time as well. DO
NOT mix old and new batteries.
16.10 Reverse polarity installation of the
batteries in the end product must be
avoided. Reverse insertion of batteries
can cause charging, and that may result
in leakage or explosion.
16.11 Remove batteries from this product
E
N
5