Maxon GPTLR Instrucciones página 2

LIFT CORPORATION Sht. 2 of 8 DSG#
NOTE: This extension plate was designed for a 102" wide body. However, this installation
is intended to be on a 96" wide body.
1. Check for correct clearances (FIG. 2-1) on vehicle
to prevent interference between vehicle and Lift-
gate. Refer to FIGS. 2-2, 3-1 and 3-2 for additional
clearances and dimensions.
3"
NOTE: The platform cutout area shown below applies to trucks and trailers. Typical
truck frame is shown. The dimensions, shown in the illustrations, are maximum.
NOTE: Refer to the platform clearance cutout area shown in FIG. 2-2. Remove any
part of the rear sill that protrudes into this area.
2. Fit the Liftgate to vehicle body by cutting
vehicle frame as shown in FIG. 2-2.
© MAXON Lift Corp. 2020
EXTENSION PLATE DIMENSIONS (GPTLR-44/55)
REAR SILL
5-1/2"
12"
PLATFORM CLEARANCE
VEHICLE FRAME CUT (GPTLR-44/55)
M-20-15
102"
78-1/2"
FIG. 2-1
BODY FLOOR
TRUCK FRAME
CUTOUT AREA
20"
FIG. 2-2
Rev. - Date: 11/02/20
BODY CROSS
MEMBER
WOODEN SPACER
3"