EN
Menu
Configuration
(SlimPAR™ 56)
Obey™ 3 Basic
Operation:
(Preset Colors)
Obey™ 3
Miscellaneous
Notes
In order for your SlimPACK™ 56 to work properly, all the SlimPAR™ 56
lights must be configured correctly. Follow the steps below to configure your
SlimPACK™ 56.
1. Press the <MENU> button on the SlimPAR
2. Press <UP> or <DOWN> to set the starting address to 001.
3. Press <ENTER>.
4. Repeat the steps for each SlimPAR™ 56 in the configuration.
Every SlimPAR™ 56 in the configuration must be in 3-CH mode to
function properly with the Obey™ 3 controller. The lights will not react
to the controller's input if they are in 7-CH mode.
1. Press the <BLACKOUT> button to disable the blackout function (LED
indicator OFF).
2. Slide the <FADE TIME> fader (middle) and the <DIMMER FADER>
(right) all the way up to turn on.
3. Press the <PRESET> button to illuminate the LED indicator above the
button.
4. Press one of the 9 preset color buttons to select a color.
5. Slide the <FADE TIME> fader (middle) to adjust the amount of time to
change from one color to another color.
6. To add a strobe, press the <STROBE> button to illuminate the LED next
to it, then slide the <SPEED TIME> fader (middle) to the required strobe
rate. Press the <STROBE> button again to deactivate the strobe button
from the middle fader.
To stop the strobe effect, make sure you are in Strobe mode. Slide the
middle fader all the way down. Press the <STROBE> button to
deactivate the function from the middle fader.
• In <CHASES> and <MACRO> and <PRESET> operating modes, the
<DIMMER> fader (right) must be set at the top to see full output from
the lights. Set this fader down to adjust the master intensity of all
connected lights.
• The <CHASES> and <MACRO> buttons on the lower left work with all
three faders.
• Pressing the <BLACKOUT> button will turn off the output of the lights,
and will also work with the <FADE TIME> fader (middle).
• The Obey™ 3 is designed to be used with 3-channel, red/green/blue
fixtures.
7
SlimPACK™ 56 QRG
56 until d001 shows.
™