Assembly Instructions - Trynex TurfEx TL20 Manual Del Propietário

Assembly Instructions

STEP 1 ATTACHING WAND TO FLOW CONTROL
A: Ensure that the gasket is in the open end of the flow control.
B: Insert the non-threaded end of the wand into the open end of the flow control.
C: Tighten the screw cap.
STEP 2 ATTACHING HOSE TO FLOW CONTROL
A: With petroleum jelly, lubricate the o-ring on the large hose insert.
B: Push the large hose insert into the handle end of the flow control until fully seated.
C: Slide the hose spring nut onto the flow control and screw on; hand tighten only.
STEP 3 ATTACHING HOSE TO TANK
A: Insert open end of black supply tube into the small black hose insert until snug.
B: With petroleum jelly, lubricate the hose insert o-ring.
C: F ully insert hose supply tube assembly into threaded tank nipple, slide spring nut to the tank nipple and screw on.
Hand tighten only.
© TrynEx International 2013 (REV A) F50920 3