Würth MSF 40 Traducción Del Manual De Instrucciones De Servicio Original página 19

▸
The diamond cut-off wheel must fit on the support
flange without any play. Do not use any adapters
or reducing pieces.
▸
Diamond cut-off wheels must be stored and han-
dled with care in accordance with the manufac-
turer's instructions. Ensure that the diamond cut-off
wheels are fitted according to the manufacturer's
instructions.
▸
Use flexible underlays if these are supplied with
the abrasive and when they are required.
▸
Ensure that any sparks caused during work
cannot pose a danger, e.g. by striking the user or
other persons or by igniting flammable sub-
stances.
▸
Protect endangered areas using flame-resistant
blankets. Keep a suitable fire extinguisher on
hand in areas with a fire hazard.
▸
The diamond cut-off wheels run on after the
machine has been switched off.
▸
Always wear safety glasses, respirator, safety
gloves, hearing protection and sturdy shoes when
working with your power tool!
▸
Damaged or vibrating tools or tools with run-out
must not be used.
▸
Avoid damage to gas or water pipes, electric
cables and load-bearing walls (statics).
▸
Pull the plug out of the plug socket before car-
rying out any adjustments, retooling or mainte-
nance.
▸
Replace a damaged or cracked auxiliary handle.
Do not operate the machine with a defective
auxiliary handle.
▸
Replace a damaged or cracked safety hood. Do
not operate the machine with a defective safety
hood.
▸
Do not switch on the machine, if device parts or
safety equipment are missing or defective.
Further safety instructions
Reduce dust exposure!
Particulates that arise when working with this
Â
machine may contain substances, which could
cause cancer, allergic reactions, respiratory
illnesses, birth defects or other mutagenic
effects. Typical of these substances are: Lead (in
lead-containing paint), mineral dust (from bricks,
concrete, etc.), wood treatment additives (chro-
mate, wood preservative), some types of wood
(oak or beech dust), asbestos.
The risk depends on how long the user or per-
sons in the vicinity are exposed to the load.
▸
Do not swallow or inhale particles. To reduce the
loading from these substances:
• Ensure good ventilation of the place of work
• Observe the directives applicable for your ma-
• Capture the particulates generated at the place
• Use accessories suitable for special work. This
▸
Use a suitable dust extraction system.
▸
Reduce the dust load by:
• Ensuring the escaping flow of particulates and
• Use an extractor system and/or an air cleaner,
• Provide good workplace ventilation and keep
• Vacuum or wash protective clothing. Do not
and wear suitable protective equipment, e.g.
dust masks that are capable of filtering out
microscopic small particulates.
terial, personnel, application and place of use
(e.g. health and safety regulations, disposal).
of origin, do not allow them to be deposited in
the surroundings.
will reduce the uncontrolled escape of particu-
lates into the surroundings.
exhaust air from the machine is not directed
towards yourself or towards other persons in the
vicinity or towards settled dust.
clean by vacuuming. Sweeping or blowing
swirls up dust.
blow, hit or brush.
19