Axis Q1635 Guia De Instalacion página 11

How to adjust focus and zoom
1. Open the product's home page and go to Setup > Basic Setup > Focus.
2. Under the Basic tab, click Open iris. If the button is inactive the iris is already open.
3. If focus has been set before, click Reset to reset the back focus.
4. Loosen the zoom puller and the lock screw for the focus ring on the lens by turning
them counter-clockwise. See .
5. Move the zoom puller and the focus ring to set zoom and focus and check the quality of
the image in the image window.
6. Re-tighten the zoom puller and the lock screw for the focus ring.
7. On the Focus page, click Fine-tune focus automatically and wait until automatic fine
tuning is completed.
8. Click Enable iris. If the button is inactive the iris is already enabled.
If needed, make further adjustments under the Advanced tab:
1. Always open the iris before focusing and enable it when finished focusing.
2. Use the mouse to move and resize the window and then click Fine-tune focus
automatically.
3. If needed, click in the Focus position bar, or on the arrows at the ends of the bar, to
further adjust the focus.
4. Click Enable iris. If the button is inactive the iris is already enabled.
How to adjust focus with the Focus Assistant
Note
• The view in front of the camera should not be changed during focus adjustment. If the
camera is moved, or if a finger or other object is placed in front of the lens, restart the
procedure.
• If movements in front of the camera cannot be avoided, the Focus Assistant should not
be used.
If the Status LED flashes either red or amber before you are able to adjust the lens, exit the Focus
Assistant and restart the procedure. See Status LED behavior for focus assistant on page 16.
1. Open the product's home page and go to Setup > Basic Setup > Focus.
2. Under the Basic tab, click Open iris. If the button is inactive the iris is already open.
3. If focus has been set before, click Reset to reset the back focus.
4. Mount or place the camera so that it cannot be moved.
5. Loosen the zoom puller by turning it anti-clockwise. Move the puller to set the zoom
level. Retighten the zoom puller.
6. Set the camera to its extreme distant-focus position by loosening the lock screw for the
focus ring and turning the focus ring fully clockwise.
AXIS Q1635 Network Camera
11
EN