Repair; Intended Environment; Power Supply - Medion Akoya P56005 Manual De Instrucciones

Tabla de contenido

Publicidad

Repair

 Leave the repair of your TFT monitor exclusively to qualified specialist personnel.
 Please contact our authorised Service Partners exclusively in the case of a necessary repair.

Intended environment

 The TFT monitor can be operated at a surrounding temperature from 0° C to +40° C and at a relative
ambient moisture level of < 80% (non-condensing).
 The TFT monitor can be stored at -20° C to +60° C when it has been turned off.
 Wait to bring the device into operation until it has reached the surrounding temperature, after the TFT
monitor has been transported.
Moisture, which can cause an electrical short-circuit, can form within the TFT monitor in the case of
wide variations in temperature or moisture.

Power supply

Please pay attention: Parts of the device will be subject to voltage, even if the mains switch has
been switched off. Pull the mains plug from the socket, to interrupt the power supply to your
TFT monitor or to release the device from voltage completely.
 Only operate the TFT monitor at an earthed socket with 100-240V~, 50/60 Hz. Ask your energy supplier
if you are not sure about the power supply at the set-up location.
 We recommend the use of protection against excess voltage for additional safety, in order to protect
your TFT monitor against damage because of voltage peaks or electrical flashes on the mains network.
 Pull the mains plug from the socket, in order to interrupt the power supply to your monitor.
 The socket must be located close to the TFT monitor and be easily accessible.
 Lay the cable so that no-one can tread on it or trip over it.
 Do not place any objects on the cable, because it could be damaged otherwise.
 Please pay attention to the fact that the standby switch does not separate the device completely from mains
electricity. The device will consume electricity in standy operation apart from this. Pull the mains plug out of
the mains socket to separate the device from the network completely.
4
English

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Md20130

Tabla de contenido