Hard Drive Assembly - SilverStone DATA STORAGE Serie Manual De Instrucciones

1. Introduction

2.1 Hard Drive Assembly

The drives can be installed at any position, there is no specific order required.
HDD1 HDD2
1. Unlock the switch at the bottom of the case and lift the front panel upward and away from the
housing to remove it.
2. Install the hard drives in the direction as illustrated.
Set your preferred RAID mode and then replace the front panel.
* The default RAID mode is Non-Raid, if you wish to change the RAID mode, please refer to 2.2
3. Connect the device to your computer and turn on the power.
4. For PC users, use the disk management tool or for Mac users, use the disk utility
to create a new partition and format the drives.
5. Done! Your external drive is now ready to use.
Note
Be careful not to damage any components, and do not force the drives into place.
If they not easily slide into place and fit, make sure the drives have been installed correctly.
Windows 7 can support hard drives in excess of 2.2TB, change the hard drive to GPT
partition under disk management in order to format the hard disk.
Note
The hard disk with GPT partition need to be reformatted under Windows XP
in order to be used.
ENGLISH
4