Detailed View; Led Indication; Led Status; Raid Switch - SilverStone DATA STORAGE Serie Manual De Instrucciones

1. Introduction

1.5 Detailed View

Front View

1.5.1 LED indication

LED status

Power Red = Power on
HDD1 Blue = hard drive detected, Flashing=Data access (read/write), OFF=empty drive bay
HDD2 Blue = hard drive detected, Flashing=Data access (read/write), OFF=empty drive bay
Non-Raid Yellow = Non-raid activated
Raid 0 Yellow = Raid 0 activated
Raid 1 Yellow = Raid 1 activated
Note
In order to determine if the correct mode is selected, please ensure the RAID switch is in the correct position.

1.5.2 RAID switch

DIP Switch RAID Mode
Non-RAID
Switch position: 2 ON, 3 ON
RAID 0 - Striping
Switch position: 2 ON, 3 OFF
RAID 1 - Mirroring
Switch position: 2 OFF, 3 OFF
Note
Except for the Non-RAID mode, two hard drives are required.
After changing the RAID mode, restart or press the reset button to confirm the new setting.
(The reset button is used to confirm RAID modes and is not to restore to factory settings)
3
Power
HDD1
HDD2
Non-Raid
Raid 0
Raid 1
RAID switch
Changing the RAID mode requires formatting the drives.
Make sure to backup all existing data first!
Rear View
ENGLISH
Fan
Reset
USB 3.0 port
Power receptacle
Power switch