PALSON Diablo Plus Modo De Empleo página 19

Robot aspirador inteligente
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

GB
Operating guide
1. Press the robot on button. When the view function is in normal
mode, press this button to turn the robot on or off.
2. With the unit switched on, press this button to stop the device in
the corresponding mode.
Turn off/Cancel/Stop
3. When setting the programmable cleaning date and time, if the
setting is incorrect or you want to cancel it, press this button to
cancel the programmed mode and return to normal status.
4. Press and hold this button for more than 5 seconds; this will
erase the entire setting and return the unit to the default setting
OK button
After setting the configuration, press OK to save it.
After fully charging the battery, the machine will begin to clean
FULL GO
automatically on repeated occasions.
If you press this button when the robot is in stand-by mode or in
operation, the robot will search for the docking station to recharge
CHARGE
itself. When the robot stops working, it will stop recharging if you
press this button again.
By pressing "Forward", the robot will move forwards cleaning in
▲ Forward button
the direction of the arrow; press "off" to stop it. If it encounters and
obstacle, the robot will stop.
By pressing and holding "Backward", the robot will move backwards
▼ Backward
cleaning in the direction of the arrow and will stop when you release
the button.
By pressing and holding the "Turn left" button for a few seconds,
the robot will turn anticlockwise until you release the button, and
◄Turn left button
will then move forwards in the indicated direction. Press "Off" to
stop the robot. If it encounters and obstacle, the robot will stop.
By pressing and holding the "Turn right" button for a few seconds,
the robot will turn clockwise until you release the button, and will
►Turn right button
then move forwards in the indicated direction. Press "Off" to stop
the robot.
If it encounters and obstacle, the robot will stop.
1. The remote control must be used within a radius of 10 metres, otherwise you will
not be able to operate the unit.
2. The robotic vacuum may not locate the docking station when you press automatic
recharge if there is an obstruction, the battery is low or in more complex situations.
36
All manuals and user guides at all-guides.com
Operating information
7. Docking station for automatic recharging
7-1 Charger display and control panel
Main view
1. LED accent light
2. Accent light indicator
3. On LED
4. Charging indicator
5. Signal transmitter
6. Positive charge point
7. Negative charge point
8. DC power socket
7-2 Docking station instructions for use and operating mode
No.
Operating guide
1
LED accent light
2
Accent light indicator Press the switch to turn the accent light on or off
The power LED will turn on when the docking station is connected
3
Power LED
to the mains, and will turn off when disconnected.
The indicator will flash for as long as the charger is connected to
4
Charging indicator
the robot.
The signal transmission is the only way to guide the robot to the
5
Signal transmission
docking station to recharge; therefore the path of the transmission
signal must be clear and free from obstructions.
The electrode and the robot are connected to charge upon contact,
Positive and negative
6-7
therefore the path must be free from obstacles while in use, which
electrode recharge
could have an impact on the recharge.
The recharging socket, or charger, is used to connect the 24V DC
outlet to the adapter and acts as the transit station for charging
DC power recharging
between robot and adapter. The charger should be securely
8
socket
attached to the wall and the adapter cable kept far away from
the charger to prevent the robot from being knocked or entangled
during cleaning.
Operating instructions
Operating information
37

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

30596

Tabla de contenido