GB
8. View of the space divider and control panel
Main view
1. Switch/selector
2. Signal head
3. Local infrared transmission point
4. Power LED
Operating the space divider:
The space divider is a robot accessory that can isolate a certain area by sending a special infrared
signal, which prevents the robotic vacuum from entering areas you do not which to clean.
Space divider instructions for use and operating mode
No.
Name
You can change between operating modes using the switch
1
Switch/selector
Off, Low, Medium and High
Move the switch
a
Off
Move the switch to this position to turn off the device
b
Low
Move the switch
select a distance of up to 4 metres according to the infrared wall
c
Medium
settings
Move the switch
d
High
you can select a distance of up to 6 metres according to the infrared
wall settings
Infrared wall signal
2
Move the switch, then you can adjust the distance of the space divider
transmitter
The local infrared transmission signal allows the robotic vacuum
Local infrared
3
to operate 50-100cm outside the range of the space divider without
transmission point
affecting its performance
The power LED will flash once every 8 seconds until the battery is low;
4
Power LED
once you set the switch to Low, Medium and High, the robot will work
as normal
1. Open the battery cover before use and insert two batteries (not included) into the compartment.
«D» Check that the batteries are inserted correctly otherwise the space divider will not work.
2. Battery duration depends on the selected distance of transmission and the operating time.
Select the appropriate transmission distance and a low transmission power to save battery
power. Do not forget to turn of the unit when not in use.
3. You may notice differences in direction, space divider infrared signal transmission and robot
reception distance due to the surrounding environment and to the movement of the robot during
use. This difference may vary according to the current surroundings and different battery energy
levels in the robot and the space divider.
38
All manuals and user guides at all-guides.com
Operating instructions
a. Off
b. Low
c. Medium
d. High
Operating information
:
to this position to turn off the device
to this option and turn on the device; you can
to the Medium option and turn on the device;
Space divider installation procedure
1. The space divider is commonly placed at the top of a staircase or at the entrance to a room.
2. The space divider can be placed in a certain position to prevent the robot from entering certain
places.
3. Where possible, remove any obstacles from the area you wish to isolate in front of the space divider
to ensure it functions correctly.
1. The space divider must be placed at the same level as the floor on which the robot
is in operation.
2. Check that the robot is able to pass through the space divider when using it for the
first time.
3. The space divider must be at least 3 metres away from the charger to avoid
interference.
39