Tabla de contenido
Publicidad
Cleaning
A
01
Cleaning
Before cleaning or performing maintenance, disconnect the oven from the power supply.
To extend the life of your oven, it must be cleaned frequently, keeping in mind that:
• Do not use abrasive powders or corrosive substances which could ruin the surfaces.
• The inside of the oven should preferably be cleaned immediately after use, when it is still warm, with hot water and soap.
The soap should be rinsed away and the interior dried thoroughly. Avoid using abrasive detergents (for example cleaning
powders, etc.) and abrasive sponges for dishes or acids (such as lime scale remover, etc.) as these could damage the
enamel. If the grease spots and dirt are particularly tough to remove, use a special product for oven cleaning, following the
instructions provided with the product.
• If the oven is in use for an extended period of time, condensation may form. Once the oven has cooled, remove the
condensation using a dry cloth.
• There is a rubber seal surrounding the oven opening which creates a heat seal. Check the condition of this seal on a regular
basis. If necessary, clean it and avoid using abrasive products or objects to do so. Should it become damaged, please
contact the customer services helpline. We recommend you avoid using the oven until it has been repaired.
• Never put aluminium foil at the bottom of the oven, as the build up of heat could compromise cooking and even damage the enamel.
• Clean the glass door (5) using non-abrasive products or sponges and dry it with a soft cloth.
1. Open the door (5).
2. Clean all oven accessories with warm water or washing up liquid and polish dry with a soft clean cloth.
3. Clean the oven interior with a soft clean cloth.
4. Wipe the front of the appliance with a damp cloth.
5. Let the oven and all accessories dry well.
WARNING! Always switch off the electricity supply before carrying out maintenance
work on the oven. In the event of a fault, contact customer services.
02
Replacing the oven light bulb
• Remove all pans and grills from inside the oven to easily access the lamp cover (3).
• Unscrew the glass cover and remove the old lamp. Dispose of it safely and ecologically.
• Insert a new G9 halogen lamp into the lamp holder.
• Note: Please do not handle the lamp with bare skin to avoid reducing its life. Use a cloth or tissue.
• Replace the lamp cover.
WARNING! Ensure that the appliance is switched off and completely cool before
replacing the lamp to avoid the possibility of electric shock or burns.
Care and Maintenance
Czyszczenie i konserwacja
Cuidados y Mantenimiento
Entretien et maintenance
Îngrijire şi întreţinere
25 W, 300 °C, type G9
24
Publicidad
Tabla de contenido
