Emerson GEODE CF370BS00 Manual Del Usuario página 22

8. Wall Control Installation
8.3
Before installing the Wall Control, place the Wall Control
in "OFF" mode by pushing "ON/OFF" Switch to the
"OFF" position.
8.4
Connect one Black Wire of the Wall Control to the
"HOT" Wire. Securely connect Wires with Wire
Connector, supplied (Figure 34).
8.5
Connect one Black Wire of Wall Control to the "LOAD"
(Black) Wire in Wall Box. Securely connect Wires with
Wire Connector, supplied.
WARNING
!
Do not connect any neutral (white) wire to this control.
Incorrect wiring will damage this control.
8.6
Screw the Wall Control into Wall Box using the supplied
Screws. Leave the Wall Control in "OFF" mode until
Fan installation is completed.
WARNING
!
Check to see that all connections are tight and that no
bare wires are visible at the wire connectors.
8.7
The Wall Control is supplied with a White, Ivory, and
Almond color Switch Covers. Choose the finish that
best suits your needs and snap the Cover onto the Wall
Control (Figure 34).
8.8
Install Decorator Wall Plate using the two Screws
provided with Wall Plate. Leave the Wall Control in
"OFF" mode until Fan installation is completed
(Figure 34).
(Continued)
SCREWS (2)
....
OFF
ON
SWITCH COVER
DECORATIVE WALL PLATE
Figure 34
22
FAN/LIGHT WALL
WALL
CONTROL
BOX
....
OFF
ON
NEUTRAL
WIRES
ETL Model No.: CF370