Philips Pure Essentials HD7690/30 Manual De Instrucciones página 6

EnglisH
6
1 Make sure the plug is in the wall socket.
2 Make sure the glass jug or thermos jug (with the lid in the 'closed/brewing' position r) is
under the filter holder.
3 Set the coffee strength you prefer with the Aroma Control knob. (Fig. 12)
To increase the coffee strength, turn the knob to the right. To decrease the coffee strength, turn the
knob to the left.
Note:When you set the coffee strength, make sure that the filter holder is in the appliance.
4 Remove the water tank and fill it with fresh, cold tap water (Fig. 6).
The level indications correspond to cups of 120ml.
5 Put the water tank back onto the appliance properly (Fig. 7).
The Aroma Control indicator moves upwards.
,
6 Take a paper filter (type 1x4 or no. 4) and fold the sealed edges to prevent tearing and
folding.
Note:If you want to use Aroma Control to determine the right balance between ground coffee and water,
do not use a permanent filter. Due to its weight, a permanent filter disrupts the coffee-water balance of
Aroma Control.
7 Open the filter holder lid and put a paper filter in the filter holder (Fig. 13).
8 Put pre-ground coffee (filter-fine grind) in the filter until the Aroma Control indicator is in
the OK position and close the filter holder lid (Fig. 14).
9 Press the on/off button to switch on the appliance.
The red power-on light goes on.
,
10 When all the water has passed through the filter, you can remove the jug from the appliance.
If you remove the jug for more than 30 seconds before all the water has passed through the
filter, the filter may overflow.
HD7692: the appliance switches off automatically after brewing. The thermos jug keeps the
,
coffee hot.
HD7690/HD7686: the coffee is kept hot on the hotplate as long as you leave the appliance
,
switched on.
11 HD7690/7HD7686: press the on/off button to switch off the appliance after use.
The appliance switches off automatically after 2 hours.
12 Remove the filter holder (Fig. 15).
13 Throw away the paper filter. (Fig. 16)
14 Let the appliance cool down for at least 3 minutes before you start brewing coffee again.
timer (HD7690 only)
You can use the timer to preset the time at which you want the coffeemaker to brew coffee.
Note:If you want to use the timer function (HD7690 only), make sure the clock is set to the correct time.
You can only set the current time when the appliance is switched off (see section 'Setting the clock' in
chapter 'Preparing for use').
Note:After a power failure, you have to set the clock and the timer again.
1 Press the timer button (Fig. 17).
The display shows the set auto-on time and the yellow timer light goes on.
,