Peavey MAX Serie Manual De Operación página 24

®
Front Panel MAX 110
1 2
ACTIVE/PASSIVE PICKUP INPUTS
1
These 1/4" inputs are included so you can choose the appropriate setting for your instrument. The gain
structure of the amplifier is modified to accommodate the outputs of different pickup configurations.
GAIN
2
This knob controls input level of the instrument.
TT BOOST SWITCH
3
This TransTube
is switched on, but the distortion level will increase depending on the level of the GAIN knob. For best
results, first set the distortion amount by adjusting the GAIN. Next, set the desired volume using the VOL-
UME knob. At this point, the clean volume will match if the TT BOOST is turned off.
BASS
4
This knob provides a shelving tone control for low frequencies and provides cut/boost of +/-15 dB. The
center point is flat. The center frequency is 50 Hz. -3 dB shelf corner frequency is 100Hz.
MIDDLE
5
This knob provides a peaking tone control for Mid frequencies and cut/boost of +/-15dB. The center point
is flat.
MID SHIFT
6
This switch controls the center frequency of the MIDDLE knob. When the switch is OUT, the middle fre-
quency is 600Hz. The middle frequency is 250Hz when the switch is pushed IN.
TREBLE
7
This knob provides a shelving tone control for high frequencies and cut/boost of +/-15dB. The center
point is flat and the frequency is 8 KHz. -3dB; the shelf corner frequency is 5 KHz.
PSYCHO-ACOUSTICS EFFECT SWITCH
8
See Psyco-acoustics effect switch description on page 9.
VOLUME
9
This knob controls the overall volume of the amplifier.
TUNE/MUTE
10
Pressing this button will engage the chromatic tuner while muting the output to the speaker. The LED
screen will indicate which note is being played while the red and green LEDs above the screen indicate
whether the note is flat (red), sharp (red) or in tune (green).
HEADHPHONE OUTPUT
11
1/8" headphone output for personal monitoring.
3 4
crunch circuit is designed so that the volume of the amp will not change when the boost
®
5 6 7 8 9 10 11 12 13