IKRA ITHK 800 Manual De Instrucciones página 26

prevent movement. Remember that freshly-
cut grass or bark is slippery.
- Ensure that somebody is nearby (but at a
safe distance) in case an accident occurs
- Do not use the device while you are in a
tree, on a ladder or on any other unstable
surface
- Maintain secure footing and good balance.
- Hold the device firmly with both hands when
the motor is running
- Do not allow the moving chain to come into
contact with any objects at the tip of the
guide plate
- Only start cutting once the chain is running
at full speed
- Do not attempt to hit a previous cut. Always
make a new cut
- Be aware of moving branches or other ob-
jects that could fall into the chain.
- Do not attempt to cut a branch with a diam-
eter that exceeds the cutting length of the
device.
- Always remove the mains plug (or always
remove the battery) from the device and
place the chain cover over the chain when
you are storing or transporting the device.
- -Keep the saw chain sharp and carefully
tensioned. Check the tension at regular
intervals
- Switch the device off before carrying out
adjustments, repairs or maintenance. Wait
until the chain comes to a stop. Remove the
mains plug (or remove the battery).
- Only use original spare parts and acces-
sories.
- Local regulations may stipulate a minimum
age for users.
- The minimum distance between the device
and overhead power cables must always be
at least 10 m.
- The user must be made familiar with the
functions of the device in a suitable way.
- The user of the device must always wear
non-slip foot protection and close-fitting
clothes.
- Do not use the device if you are tired or ill,
or under the influence of alcohol or other
drugs.
- Keep people away while you are using the
machine. Pay attention to falling branches.
- Use the transport protection cover when
GB | Operating Instructions
If a foreign object becomes caught in the cut-
ting tool or similar, stop the drive immediately
and wait until the cutting tool comes to a stop
(remove the mains plug or remove the bat-
tery). Put on gloves suitable for removing the
foreign object. After you remove the foreign
object, you must check the cutting tool and
the machine/safety equipment for possible
damage, stop work and replace these defec-
tive parts with the spare parts specified by the
manufacturer.
Then carry out a test run before continuing to
work.
If the mains supply cable of this device is dam-
aged, it must be replaced by a special supply
cable that can be obtained from the manufac-
turer or its customer service department.
Safety instructions for hedge trimmers:
-
-
-
-
• Check the hedge for hidden objects such as
• The hedge trimmer may not be used by per-
GB-8
transporting and storing the device
Keep all parts of your body away from
the cutting blades. Do not try to remove
cut-off matter with the tool running. Do
not try to hold material to be cut off with
your hand. Remove cut-off matter that is
stuck between the blades only with the
tool being switched off! When working
with hedge trimmers even a short moment
of inattentiveness may result in severe in-
jury.
Hold the power tool by its insulated
handling surfaces as the cutting blades
might get in touch with the tool's own
power cable. If the cutting blades should
accidentally cut into a live power cable
this might turn metal parts of the tool 'hot'
thereby causing an electric shock.
Carry the hedge trimmer at the handle
with the cutting blades standing still.
Always put on the protection cover when
transporting or storing the hedge trim-
mer. Careful handling reduces the risk of
injury through the cutting blades.
Keep the cable away from the cutting
area. When working with the trimmer the
cable might be hidden in bushes and ac-
cidentally cut through.
wire fencing before beginning to cut.
sons who are younger than 16 years of age