Fcc Statement - Pet Mate Selective 356 Instrucciones De Operación

Press the '4 WAY' button to choose between:
+ = Energy saving mode OFF
+ = Energy saving mode ON
Press 'SET' to save setting.
9.2 Flap does not open in response to programmed I.D. Disc or microchip
• Check '4 WAY' lock is programmed to permit access in the chosen
direction.
• The energy saving circuitry may have been activated and will be shown
by a short flash on the red LED every 2 seconds. Do not move the flap
until the LED stops flashing.
• Check batteries are correctly orientated (Fig.3) and not in need of
replacement (See Section 7).
• Check the I.D. Disc is correctly fitted to cat's collar (See Section 5.2).
• If possible, try operation with another programmed I.D. Disc / microchip
to ascertain if there is a fault with a particular I.D. Disc / microchip.
• Check cat flap is mounted at correct height (See Fitting Instructions).
• If all else fails, remove batteries and wait a minimum of 5 minutes. Refit
batteries and then perform a 'FACTORY RESET' (See Section 8) before
reprogramming (See Section 3).
9.3 Flap has not fully closed
This problem may happen very occasionally and will normally self correct
within 30 minutes. If problem persists remove batteries for 5 minutes
before replacing when correct lock action should be resumed.
9.4 Difficulty in setting required functions
• Buttons need to be pressed firmly.
• Remember to press the 'SET' button after making any change to save
the setting.
9.5 Flap does not lock
• Check flap not in 'TRAINING MODE' (slowly flashing arrows).
• Wait 15 minutes for self correction.
8

FCC STATEMENT

1. This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including
interference that may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with minimum distance 20cm between the radiator and your body.
9