DeWalt DC727 Manual De Instrucciones página 11

Taladro/destornillador inalámbrico con embrague ajustable
Ocultar thumbs Ver también para DC727:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

8. With variable speed drills there is no need to center punch the point
to be drilled. Use a slow speed to start the hole and accelerate by
squeezing the trigger harder when the hole is deep enough to drill
without the bit skipping out. Operate at full-on after starting the bit.
Drilling in Wood
Holes in wood can be made with the same twist drills used for metal.
These bits may overheat unless pulled out frequently to clear chips
from the flutes. For larger holes, use low speed wood bits. Work that
is likely to splinter should be backed up with a block of wood.
Drilling in Metals
Use a cutting lubricant when drilling metals. The exceptions are cast
iron and brass which should be drilled dry. The cutting lubricants that
work best are sulphurized cutting oil or lard oil; bacon grease will also
serve the purpose.
Drilling Masonry
Use carbide tipped masonry bits at low speeds. Keep even force on
the drill but not so much that you crack the brittle materials. A smooth,
even flow of dust indicates the proper drilling rate.
Operation as a Screwdriver
Select the desired speed/torque range using the dual range gear
shifter on the top of tool to match the speed and torque to the planned
operation.
Insert the desired fastener accessory into the chuck as you would any
drill bit. Make a few practice runs in scrap or unseen areas to deter-
mine the proper position of the clutch collar.
MAXIMUM RECOMMENDED CAPACITIES
DC727, DC728
WOOD
1-1/2"
STEEL
3/8"
CONCRETE
3/16"
MAINTENANCE
Cleaning
CAUTION: With the motor running, blow dirt and dust out of all air
vents with dry air at least once a week. Wear safety glasses when per-
forming this. Exterior plastic parts may be cleaned with a damp cloth
and mild detergent. Although these parts are highly solvent resistant,
NEVER use solvents.
CHARGER CLEANING INSTRUCTIONS
WARNING: Disconnect the charger from the AC outlet before
cleaning. Dirt and grease may be removed from the exterior of the
charger using a cloth or soft non-metallic brush. Do not use water or
any cleaning solutions
Accessories
Recommended accessories for use with your tool are available at
extra cost from your local service center.
If you need any assistance in locating any accessory, please contact
D
WALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD
E
21286 or call 1-800-4-D
CAUTION: The use of any non-recommended accessory may be
hazardous.
Repairs
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustment (including brush inspection and replacement) should
be performed by certified service centers or other qualified service
organizations, always using identical replacement parts.
Three Year Limited Warranty
DC759
D
WALT will repair, without charge, any defects due to faulty materi-
E
als or workmanship for three years from the date of purchase. This
1-1/2"
warranty does not cover part failure due to normal wear or tool abuse.
1/2"
For further detail of warranty coverage and warranty repair informa-
1/4"
tion, visit www.dewalt.com or call 1-800-4-D
9
WALT (1-800-433-9258).
E
WALT. This warranty
E

Publicidad

Tabla de contenido
loading

Tabla de contenido