Task 2: Installing The Supertrak Card - Promise Technology SUPERTRAK EX8760T Guia De Inicio Rapido

SuperTrak EX8760T, EX8768 Quick Start Guide

Task 2: Installing the SuperTrak Card

The SuperTrak EX RAID controller card fits into any available PCI-Express X8
slot. To install the SuperTrak card:
1. Remove the cover of your PC or enclosure.
2. Remove the inside slot cover of an available PCI-Express X8 slot on the
motherboard.
3. Install the SuperTrak card into an open PCI-Express X8 slot.
4. Fasten the SuperTrak card bracket to the PC or enclosure case.
Before installing the SuperTrak EX Controller card into an existing
system, backup any important or useful data. Failure to follow this
accepted practice could result in data loss.
Promise does not recommend multi-lane and fan-out cables
longer than 3m (118 inches) because they have not been tested
with the SuperTrak controller.
The SuperTrak EX Controller cards are PCI Plug-n-Play (PnP)
devices. No changes are necessary in the motherboard CMOS/
BIOS Setup for resources or drive types in most applications.
Warning
Important
Note
4