DR.BEI GF3 Manual De Instrucciones página 13

c. Switch Between Modes
The product has a Cleaning Mode, a Soft Mode, and a Massage Mode.
The Cleaning Mode is for normal cleaning and applicable to most people; the Soft Mode is for new users of water
flossers or those with sensitive teeth; with the Massage Mode, teeth are cleaned and gums are massaged.
Cleaning Mode
Soft Mode
Massage Mode
Power Indicator
Power Button
* Press the power button and hold for at
least 1.5 seconds.
d. Clean Teeth
1. Place the nozzle in your mouth and aim at your teeth, place it between teeth or gums; make sure that the water
flow is perpendicular to the part for flushing and your mouth is slightly open.
2. Press down the power button for cleaning the teeth. During the use, keep the product upright to prevent
overflow of water as the water suction tube inside the water tank may come out from the water.
3. The product will shut off automatically after it has run for 2 minutes; if you wish to use it for some more time,
press the power button.
e. Clean and maintain
Clean After Using the Product
There is a risk of bacteria propagating, so you are advised to wash and dry the product thoroughly before storing
it.
1. Switch off the product. Open the flip top and dispose of the water in the
water tank.
2. Press the power button again to switch on the product and drain the
water inside the water tank.
Power On:
Press down the power button to switch on the product. For first use, the
product will work in the cleaning mode by default.
Switch between modes:
To switch between modes, press the power button again in 10 seconds
after the product is switched on.
Memory Mode:
When certain mode is used for over 10 seconds, the product will store the
mode as the memory mode. It will start in the same mode at the next boot.
Shut Down:
To switch off the product, press and hold the power button.
Alternatively, press the power button to switch off the product after it has
run for 10 seconds;
or long press the power button until the product shuts off;
or the product shuts off automatically after 2 minutes.
11