ENGLISH
4
Introduction
Full-body tanner
With this tanning appliance you can suntan comfortably at home.The tanning lamps emit visible
light, heat and ultraviolet light, giving you the impression you are sunbathing in real sunlight.This
appliance tans your whole body, including the sides, evenly from head to toe.
A timer ensures that each tanning session does not last longer than 30 minutes. Just as with natural
sunlight, overexposure must be avoided (see chapter 'Tanning and your health').
General description (fig. 1)
A
Tube lamps and starters of the couch
B
Tube lamps and starters of the canopy
C
Facial tanner - HB589 only
D
Switches for facial tanner - HB589 only
- O = facial tanner off
- I = facial tanner on
- I and , = facial tanner on at 75% of its full intensity
- I and m = facial tanner on at full intensity
E
Fan for body cooling
F
Switches for fan
- O = fan off
- I = fan on
- I and n = one fan on
- I and b = both fans on
G
End cover
H
Mains cord
I
Legs of the frame and side panel
J
Connecting cable between couch and canopy
K
Fan to cool the facial tanner (HB589 only)
L
Vents and fans to cool the tube lamps
M
Acrylic sheets
N
Protective foils
O
Protective goggles (2 pairs)
- (type no. HB072/service no. 4822 690 80147)
P
Screws and bolts
Q
Spanner and screwdriver
R
Timer
Important
Check if the voltage indicated on the canopy corresponds to the mains voltage in your home
before you connect the appliance.
Water and electricity are a dangerous combination! Do not use this appliance in wet
surroundings (e.g. in the bathroom or near a shower or swimming pool).
If you have just been swimming or have just taken a shower, dry yourself thoroughly before
using the appliance.
The appliance must be connected to a circuit that is protected with a 16A standard fuse or
an automatic fuse.
Always unplug the appliance after use.
Make sure the cord does not become trapped under one of the legs when you move the
appliance.
Make sure the vents to cool the tanning lamps in the canopy and in the couch remain open
during use.