Connecting To A Network - Toshiba dynadock U3.0 Guía De Usuario

22
Setting Up the dynadock™ and Connecting Peripherals
2
Plug the other end of the HDMI
HDMI
NOTE
NOTE
NOTE
You can customize the video settings of the dynadock™. See
"Adjusting video settings" on page 28

Connecting to a network

Connect one end of a network cable (not provided) to the Network
port (RJ-45) on the dynadock™ and the other end to your network.
If the network is not automatically connected, configure the
network properties of the Ethernet adaptor as follows:
❖
In Windows
Sharing Center, and then Change adapter setting.
❖
In Windows Vista
network status and tasks, and then Manage network
connections.
❖
In Windows
Connections.
®
out port on the dynadock™.
®
The DVI or HDMI
the display and computer, while the VGA cable provides analog
communication. If your display has a DVI or HDMI
DVI cable or HDMI
The display cable can be connected/disconnected at any time
without disconnecting the dynadock™ from your computer.
If no output is seen on the display connected to the dynadock™, the
current video resolution setting may not be supported by the display.
This can happen if the display does not report its supported modes
to the dynadock's DVI component. Adjust the resolution of the
external display until an image appears. For more information, see
"Using the TOSHIBA dynadock™ U3.0 Utility" (page
®
7, click Start, Control Panel, Network and
®
, click Start, Control Panel, View
®
XP, click Start, Connect to, and then Show all
®
cable (not included) into the
cable provides digital communication between
®
cable to obtain finer resolution options.
for more information.
®
port, use the
26).