Kohler K-6504 Guia Del Usuario página 6

Inlet
Spout Tube
Assembly
O-Ring
Sleeve
Spout Tube Bracket
Troubleshoot the Sheetflow
If the sheetflow is not complete and breaks occur:
Verify the spout tube and shroud are level. Make any adjustments
as needed.
Verify that the shroud is centered on the spout tube assembly.
Make any adjustments as needed.
Remove any excess sealant from below the spout.
Verify the bath is clean.
NOTE: Do not clean the bath with wax or polish. Wax causes water
to bead on the surface of the bath and will cause breaks in the
sheetflow.
Verify the holes/slots of the bath components are not blocked.
Remove any obstruction.
If the sheetflow is not complete and breaks in the sheet flow still
occur:
Loosen the wall fasteners from the bath bench/rim.
Raise the shroud about 1/4" (6 mm). The bottom of the shroud
and the bottom of the bracket on the spout tube should be at the
same height.
Retighten the wall fasteners. Do not overtighten.
1001719-5-C
Bath Bench/Rim
Wall Fasteners
1/8" (3 mm)
6
Spout Tube
Shroud
Kohler Co.