Operation - Tripp-Lite B118-008E-UHD-2 Manual Del Propietário

Installation
Cascade Installation:
Notes:
• Only three levels of splitters can be cascaded in a single installation.
• For best results, the length of the HDMI cable(s) connecting the source to the
splitter or splitter to the monitors must not exceed 6 ft. (2 m) for 4K x 2K and
16 ft. (5 m) for 1080p resolutions. Tripp Lite's P569-XXX-CERT HDMI 2.0 cables
are recommended.
1. Make sure the power to all devices you will be connecting is turned off.
2. Connect your HDMI source to the Input port on the first-level splitter.
3. Connect an available Output port on the first-level splitter to the HDMI
Input port on the second level splitter.
4. Repeat Step 3 for each additional splitter you wish to add (no more than
three levels of splitters).
5. Connect an available Output port to the display's HDMI input port.
6. Repeat Step 5 for each remaining Output port in the installation.
7. Connect the included power supplies to each splitter in the installation and
plug them into available AC outlets.
8. Turn on power to the HDMI source and all displays connected.

Operation

1. For each display connected to the splitter, the corresponding LED on the
front of the unit will illuminate blue.
2. Before outputting a signal, the splitter will read the EDID information of
each connected display, while the HDMI source determines the appropriate
output for all displays.
Note: The lowest video resolution and audio format of the connected displays will
be outputted. Ex. If one TV supports 1080p and stereo audio and another supports
1080i and 5.1 audio. The HDMI source will output 1080i and stereo audio.
3. Instead of the attached source determining the video output credentials,
choose between 16 built-in EDID DIP switch settings that are user-
adjustable, as shown in the table below.
5