Schlage Control FE410F Instrucciones Para La Instalación página 2

Check door dimensions.
See consumer.schlage.com/Service-Support for door
preparation instructions if dimensions are different.
Crossbore
Diameter
2 " (53 mm)
Z\,
L The firecup cannot be installed on a 1
door, and the lock will not retain the UL rating.
Install the lock
1
Install bolt and strike.
Use provided bolt!
1a Adjust bolt length, if necessary.
Measure the backset. If the
measurement is 2C\," (60 mm) no
Backset
adjustment is necessary.
If the measurement is 2C\v" (70 mm), extend the bolt.
Twist the faceplate.
1b If desired, change to the square-corner faceplate.
Use a flathead screwdriver
to pry the faceplate off.
Backset
2 " OR 2
C\,
(60 mm OR 70 mm)
1" (25 mm) Hole
5 " OR 4"
Z\x
(140 mm OR 102 mm)
Door Thickness
1C\," to 1C\v"
(35 mm to 44 mm)
" (35 mm) thick
C\,
CAUTION
Make sure the button
pops into place.
Press the square-corner
faceplate into place.
1c Install the firecup into the lower hole.
L DO NOT install the firecup on a 1C\," thick door.
"
C\v
Opening should
face the outside
1d Install the bolt and latch into the door.
If the bolt does not remain retracted throughout installation, locking and
unlocking could be reversed, resulting in an unsecured residence.
Make sure the word
TOP faces up when
installing the bolt.
Make sure
latch bevel
faces strike
plate.
1e Install the strikes.
Drill pilot holes Z\," x 3" deep, 2 places.
Reinforcement strike
Fire cup not
required for
deadbolt hole
of the door.
CAUTION
Actual
Size (4)
Optional
OR
Actual Size
Strike and
reinforcement plate