Uline H-8529 Manual Del Usuario página 4

6. Place rear flange of the bottom (6) into the bottom
lances of the back. The flange with the two holes
should face the front, hanging over the sill. Insert
bolts through the bottom and sill with the head
facing the front of the unit. Secure with two nuts.
(See Figure 6)
7. Set the unit upright and tighten all nuts and bolts
around the entire unit.
8. Insert the shelf (5) at desired level. (See Figure 7)
5
NOTE: In order to place the shelf, tilt it slightly
to the left or right before inserting into the unit.
9. Attach the left door (8) to the unit by placing the
door on the hinges, aligning the hinge holes,
dropping the pins (15) into the slots, then placing
the flat end of a screwdriver on the hinge pins and
tapping them in with a hammer. (See Figure 8)
PAGE 4 OF 15
ASSEMBLY CONTINUED
Figure 6
6
Figure 7
8
10. Attach the right door (9) to the unit in the same
way you attached the left door. (See Figure 9)
HANDLE/LOCKING SYSTEM INSTALLATION
1. Place the locking handle (11) on the right hand door
and fasten with two #8-32 x 1/4 slotted hex-head
bolts and lock washers. (See Figure 10)
Figure 8
15
Figure 9
9
Figure 10
11
1120 IH-8529