Tabla de contenido
Publicidad
EN
5
MAINTENANCE/COMPONENT
REPLACEMENT
No special maintenance is required.
Occasionally dust may accumulate inside the housing and
coat the transparent dome/trim ring. In this case, power
the unit off and remove the dome so that it is away from
the camera. While using proper eye protection, clean the
dome by using clean compressed air from a spray can, and
microwave safe paper towels, and reseat the dome.
CAUTION: Do not remove camera from pan/tilt.
Remove the entire receiver/driver, pan/tilt, and
camera assembly from the AutoDome system to
prevent damage to the flexible cable and connector.
© 2003 Bosch Security Systems
Maintenance/Component Replacement
Page 13 of 16
Publicidad
Tabla de contenido
